Hello!

Im pretty new to this, but I'ved played around with carbon laminating a while. My next project is to make a carbon saddle for my racebikes.


The saddle is the same as the picture. My question is how to mould this without ruining it. And how do i cover up the stitching and the logo wich is sunk into the "leather", maybe it will do fine wit some filleting wax?

Another question is how i could do the rails (metalpieces underneath) or something similar to them without sanding out a plug. The best would be to just get some mould from them and laminating it, but how do i get them free from air in the process?

/Andreas