Resin Infusion problems


Resin Infusion problems
View
Options
Author
Message
tanny0410
tanny0410
tanny0410
posted 11 Years Ago HOT
Junior Member (11 reputation)Junior Member (11 reputation)Junior Member (11 reputation)Junior Member (11 reputation)Junior Member (11 reputation)Junior Member (11 reputation)Junior Member (11 reputation)Junior Member (11 reputation)Junior Member (11 reputation)
Group: Forum Members
Posts: 1, Visits: 5
Hi,

I have been having trouble infusing a 9 mm thick basalt/vinylester laminate and have a few questions.

1. Should the flow media cover cover the entire laminate or should it only cover a part of it? Should it be in contact with the outlet spiral as well?
2. The flow on the top is much faster than at the bottom due to the flow media. Is there anything I can do to speed up the flow at the bottom surface?

Some help would be greatly appreciated.

Regards,

Tanmay
Reply Like 5
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
Resin Infusion problems
tanny0410 - 11 Years Ago
     This is a pretty thick infusion. What exactly are your problems? What is your layup schedule? Can...
brainfart - 11 Years Ago
     This ^ Also, if you're having problems with the resin moving through the top of the laminate too...
Hanaldo - 11 Years Ago
             Use a slower infusion mesh, I've seen 25thk laminates successfully infused (although not tried it...
ChrisR - 11 Years Ago
     You are definitely towards the limit of infusion in terms of thickness. You ideally would need...
Warren (Staff) - 11 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 2 queries. Compression Enabled.
Explore
Messages
Mentions
Search