Can't get peel ply off cf part...

Author	Message
BlackNDecker	BlackNDecker posted 11 Years Ago HOT Topic Details
Group: Forum Members Posts: 92, Visits: 251	What am I doing wrong? Quick vacuum bagging test to see where bridging would occur... But I can't get the peel ply of the back. Should I over lap the peel ply a couple centimeters past the cf? I followed the directions on the Easycomposites tutorial. My lay up process was: 1. 200 g cf x 3 layers 2. Peel ply 3. Infusion mesh 4. Spiral tubing 5. Vacuum bag Any help would be appreciated. Thanks!
	Reply Like 2

Merge into selected topic...

Merge into merge target...

Merge into a specific topic ID...

BlackNDecker - 11 Years Ago

Damn...this was way too hard. Is there a trick to make it easier?...

BlackNDecker - 11 Years Ago

fgayford - 11 Years Ago

Hanaldo - 11 Years Ago

carbonfibreworks - 11 Years Ago

ajb100 - 11 Years Ago

Available here .

FLD - 11 Years Ago

matthieutje65 - 11 Years Ago

Hanaldo - 11 Years Ago

Login
Remember Me Reset Password Resend Validation Email Login	Facebook Google