Hi..
I'm new to making composite parts and after some advice..This is the first mold I've made.. Its been cleaned up since this picture was taken.. 
It's a deep Box shaped mold and have concerns about the best way to lay the carbon fiber cloth In it without getting creases. 
With something like this would it be viable to cut the cloth into multiple sections to get it in tidy.. Or would it go in, in one piece and be manipulated into place once its wetted out? 
Any advice would be appreciated.. 

Your best chance to avoid bridges is to cut the carbon into sections. You can use scotch tape to develop your patterns and then transfer the pattern over to poster board as templates to cur your cloth.

Jason