Hi,i've already decided what products i need for build a carbon fiber tube (braided sleeve, appropriate resine and hardner..)
and now before i place the order i'd like to understand what type of carbon rigid plate buy to build a small
plate (roughly 47mm x 36mm) with i think a 2mm thick to substain the 5208-150 brushless gimbal motor.
What i'd like to make it's something similar to
this plate but without this curves..
I see you have two types of rigid plates:
the
The pre reg and
the WetLay oneI do not have any issues of cosmetics.. it's only a support that goes under the brushless motor plate...
so no one could see it...
I do not have also nay issues of precision.. (i read that the expensive one could be more precise..)
if it will be 2,2 or 2,6 millimiters does not matter..
I only need a strong sheet..that could support the brushless motor to the two clamps..
Ok i know there is some plate already made..but i prefer to build one for my self.. with only the holes that my motor need..
In order to make the right holes..i do not see any Tips for a drill on your site..?
What kind of drill do you suggest..?
Should i buy a "dremel" ...
In order to cut the sheet into the plate dimension (47 mm x 36mm )
to have some plates.. what kind of tool do you suggest to me...?
This set in union with a "Dremel"...?
Or
this product ...?
Thank you very much for the time you dedicate in answering to me..
I'm wait for your reply before to place the prder..
Paul.