Simple Carbon Dashboard Project

THE PROJECT - a simple carbon fibre dashboard, consists of a flat plat 6" wide with a 11/2" radius along one edge. Wet layed.

THE MOULD - I've use a simple sheet of 'Conti' board (chipboard with a white laminated surface) with half a plastic pipe to form the radius. This has be filled and flatted down with 800 Grit wet and dry, I will flat the whole mould with 1200 grit next. I attached a photo for reference.

http://www.talkcomposites.com/Uploads/Images/92146649-add9-4bac-85e7-6e21.JPG

QUESTIONS/ ADVICE

1) I plan to use Easy lease release agent followed by two coats of release wax, is this ok?

2) As I'm wet laying what Gel coat and resin system do you recommend?

4) I plan on mixing gently with a hairdryer on hand to help remove any bubbles in the gel coat.

5) Was planning of using 'Pro Finish 2/2 twill carbon fibre (to help perserve the look of the fibre and cutting would be easier), would 3 sheets be sufficent, its not structure?

6) Bristle roller.

Have I missed anything else ? Thanks in advance - this will be my first time working with Carbon however I have laminated G/F before.