By Dentex - 9/3/2020 12:26:00 PM
Greetings,
I am new to composites work, but did a lot of reading and research on topics that might be helpful to me.
My plan is to use pre-preg carbon with oven and vacuum system to produce sport equipment.
I hope I will find helpful info here and in conversation with other members.
Best wishes;
Dentex
|
By Dentex - 9/4/2020 12:58:17 PM
Thanks for Your welcome Warren.
I've read quite a lot from this and other forums, but my concerns are related to some specific issues with my project since it's quite complex part for lay up but in the other hand not so much that's impossible to do it.
I understand that going pre - preg route can be expensive but it's the best way to do it for the parts I am trying to make so let's hope for the best 
|
|