By ronanobrien - 10/17/2018 12:33:11 PM
Hello,
I recently bought GlassCast 3 Clear Epoxy Coating Resin for a small project I am working on (an artistic project, not a penny floor), however found the resin to be far too viscous as i require the resin to drain off the object i am applying it to in order to leave the object with a very thin coat on the surface that will not require polishing . I had previously used resin however bought from a different supplier in Vienna which i think was used for building yachts but i no longer have the can. Any info on different products or methods will be much appreciated cheers ronan
|
By Warren (Staff) - 10/29/2018 10:03:53 AM
yes, the GlassCast 10 does not lay as smooth so more undulations, ripples or dimples are likely compared to the GlassCast3. GlassCast 3 wants to be poured around 1.6-2.0mm thick as a minimum to get a smooth finish. Poured over artwork, it should be possible to pour just under 2mm thick per pour with a little excess running over the edge.
|
|