By Franz Mussner - 9/10/2018 3:17:48 PM
Hey everyone! I am planning to do a F1 seat,
i was wondering if there is such thing as a foam wich gets hard after a while so that you can use it as a mould?
Or how would you build the mold?
thanks!
|
By Warren (Staff) - 9/11/2018 11:42:06 AM
A lot of the kits you see use fast curing resins and plastic beads to bulk it out as you sit on it during the cure. Doing something similar as Hanaldo says would get you the shape you can use to make the pattern.
If you wanted the full technical look, you could even replicate the extraction straps and bits and bobs to make it look more real.
This PDF shows the single seater extractable seat rules which has some good pictures and information:
|
|