By Thomb - 8/13/2017 9:00:26 PM
I want to make a mould of these 2 repaired end caps from carbon, i never did a shape like this deep and would like to know what is the best way to go?
Put them flat on a plate and mould or maybe a 2 piece?
thanks
|
By Fasta - 8/14/2017 10:07:06 AM
That doesn't look like it would release if on a board as a one piece mould.
May have to be a split mould?
One piece mould would be nice and easy though. You should blank off the smaller open end and mould right across this area.
|
|