By SebRS - 4/5/2012 12:34:55 PM
Hi there!
I need to build a CF part wich will go in a high temp environement (inside an engine bay)
as i need the part to have a nice glossy finish, can i use the epoxy clear gel coat before vacuum infusion?
And if so, is the gel coat need to full cure, or tacky when i build the reinforcement frame before start infusion?
Kind regards,
Seb.
|
By SebRS - 4/10/2012 12:18:44 PM
Hi both Matt,
thanks for this replys.
the part i will try to produce is an engine cover. original is plastic, and there is no stress on it (just a cosmetic part).
i ordered high temp epoxy resin last time, so i think this part will infuse with this resin.
I think i will try 2 parts:
1 only High temp infusion, no clear gel coat.
If result is not good, then i will try clear epoxy gel coat.
Thanks for your help (here and by e-mail)
Regards,
Seb.
|
|