Yes, I tried the unimould. I made perfect 3pcs split mould for the roof. It worked perfectly as i used EC pattern coat high gloss over the styrospray 1000. But next mould was the front mounting panel, with that i had bit of bad luck.. I didnt use high gloss layer, as just add the releasing agents over the styrospray and that was a mistake. Because unimould is making more heat than my previous epoxy moulds, i got a new problem of styrospray coating releasing from the foam. So in order to use unimould system, i must coat the styrospray, that it handle the heat better. I like the fact that unimould gelcoat is easy to sand, if there is imperfections, as the epoxy tooling gelcoat is really hard stuff. So Now i must make a new front mounting panel, its a shame as it takes a lot of time and work, because it has lot of tiny and complex details.

Bonnet panels are not bond together. I will bond them later on, I must remove the temporary yellow vinyl wrap first. Tomorrow is time to trim and polish the door skin.

New Plug photos

More photos 

Hi!